From what I understand this is a common thing with the Mavic mini Series. I have had mine for a month and haven't crashed it once. I haven't run into trees or anything that would have damaged the gimbal. During today's flight, the camera began to spaz and the gimbal began to lock up. And when I managed to get it to work it would work for a bit and then lock up angled with the top left side(Front view) to the top and the bottom right to the left. The gimbal itself doesn't seem to be broken because it has a full range of motion. From what I can feel the axis that controls the cameras left and right (Roll) lean sometimes locks up. I attached the video of when I first noticed the issue belowFirst time I saw the jitterHere you can see that the gimbal was working perfectly and then began to spazThe video below shows the gimbal later that day with full range of motion.I have tried a few things. 1) I made sure the gimbal wasn't pushed in and wasn't colliding with anything as it tried to do its thing. 2) I used some compressed air made to clean tech to try clear any debris in the gimbal and tried to fly it after and it looked like it was working fine for a little and then I got the overloaded message and then stuck once again. It seems like only the left-right(Roll) axis is struggling. When moving the gimbal by hand it feels like once in a while it gets stuck. Almost like there's a grain of sand or something like that in it. And then it lets go and moves freely again.Any tips or info are very appreciated. I hate seeing it on the ground like this instead of in the air getting great footage. Thank you!Gimbal looks like it has full motion but at one point(9 seconds) gets stuck and the roll(side to side) stops adjusting for drone tilt via /r/drones https://ift.tt/39yViTb
Comments
Post a Comment